Hi, im looking to set up a card on my asterisk box, to act as a T1 trunk, but i am a noob regarding this type of cards, im gonna connect another server that will use analog telephones, but will get the service from the asterisk pbx, which is connected to 2 SIP trunks, i will post the requirements of this server, any help would be greatly appreciated, thanks in advance for you help.
Jaime.
This requires 3 full T1 lines
Per T1 trunk
grouping: float
search type: first
protocol: HDLC
in band signaling: DTMF
select sequence: DSEQ
Hunting: Dont care
Hunting selection: HDLC
framing/line coding: ESF/B8ZS
Active B channels: 1-23
B channel negotiation: No
D-channel: 24
Facilities: None (i.e. no ANI, FastCall, etc.)
CO switch: A supported switch
CSU: Tylink Open network server 100 or equivalent (including remote and local loopback modes) the customer is responsible for installation of CSU.
Those were the requirements for the server, hope some one can help me find out what card is the one i need, again thanks in advance.