Zaptel and Cologne Chip

[atnonis]

Hello

have anyone tryed to install zaptel with a quad bri card using cologne chip??

atnonis

[chipsake]

#lspci -v
…
0000:03:02.0 ISDN controller: Cologne Chip Designs GmbH: Unknown device 08b4 (rev 01)
Subsystem: Cologne Chip Designs GmbH: Unknown device b520
Flags: medium devsel, IRQ 10
I/O ports at a800 [size=8]
Memory at f0100000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2

#ztcfg -vvv
Zaptel Configuration

SPAN 1: CCS/ AMI Build-out: 399-533 feet (DSX-1)
SPAN 2: CCS/ AMI Build-out: 399-533 feet (DSX-1)
SPAN 3: CCS/ AMI Build-out: 399-533 feet (DSX-1)
SPAN 4: CCS/ AMI Build-out: 399-533 feet (DSX-1)

Channel map:

Channel 01: Clear channel (Default) (Slaves: 01)
Channel 02: Clear channel (Default) (Slaves: 02)
Channel 03: D-channel (Default) (Slaves: 03)

3 channels configured.

[atnonis]

so to install the qozap driver with support for asterisk
i 've download the 0.2 version of bristuff driver and run the install.sh script, it downloads particular versions of zaptel, asterisk and libpri and then patch them. have u managed to install a newer version of asterisk,zaptel,libpri?
the problem i have is that the driver wont load properly. i dont remember exactly the messages i got because i re-install slackware (which dist are u using?) and installed the particular versions.

Thanks
atnonis