Modprobe wcfxo - No such device

Asterisk Asterisk Support
1

Help, anybody!
I have bought TDM11B card from Digium. I have install it, and zaptel drivers. When I enter command “modprobe zaptel” it goes fine. Then I enter command “modprobe wcfxo” it goes well. Finally I enter command “modprobe wcfxs” and it gives me this error message.

/lib/modules/2.4.20-8/misc/wcfxo.o: init_module: No such device
Hint: insmod errors can be caused by incorrect module parameters, including invalid IO or IRQ parameters.
You may find more information in syslog or the output from dmesg

I have look at “wcfxo.o” and I can’t find anything usefull. Has anybody get this error mesage? I didn’t configured those parameters (IO or IRQ). Where can I configure them?

2

You do not use the wcfxo driver with the TDM* card. The proper driver is wcfxs or wctdm which it has recently been renamed. Either should work but the ecfxo driver is only for the discountinued X100P card.

3

Thank you. Acordenly to Andy Powell “Getting Started With Asterisk v0.1a” I do need them. Do you have any tutorial that shuld work for me with TDM11B card?

Which tutorial did you use?