Hi all
Boring intro: My first time on Asterisk …
- Setup used: RHEL4 + TDM400P + 1 FXO + Asterisk 1.4.17 + Zaptel 1.4.8
- I compiled the sources before inserting the analog card. SIP endpoints were configured and working good.
- After inserting the card, i have the following outputs:
ztcfg -vv
Channel map:
Channel 01: FXS Kewlstart (Default) (Slaves: 01)
1 channels to configure.
ztscan
[1]
active=yes
alarms=OK
description=Wildcard TDM400P REV I Board 1
name=WCTDM/0
manufacturer=Digium
devicetype=Wildcard TDM400P REV I
location=PCI Bus 05 Slot 05
basechan=1
totchans=4
irq=169
type=analog
port=1,FXO
port=2,none
port=3,none
port=4,none
Is it normal to get (1 channels to configure.) instead of getting ( 1 channels configured)?
Should i continue exploring Asterisk or something wrong happened and i have to re-work on this issue?
zaptel.conf
fxsks=1
loadzone = us
defaultzone = us
zapata.conf
[trunkgroups]
[channels]
usecallerid=yes
hidecallerid=no
callwaiting=no
threewaycalling=yes
transfer=yes
echocancel=yes
echotraining=yes
context=incoming
signaling=fxs_ks
channel => 1
I already did RTFM and googled around. But still not sure of this particular point.
Thanks in advance.