ZT_CHANCONFIG failed on channel 1: No such device or address

Asterisk Asterisk Support
1

hello
i have the problem in
Zaptel Hardware Configuration
when i type fellowing commands
/sbin/ztcfg -vv

i get

Zaptel Version: 1.4.12.1
Echo Canceller: MG2
Configuration

Channel map:

Channel 01: FXO Kewlstart (Default) (Slaves: 01)
Channel 02: FXS Kewlstart (Default) (Slaves: 02)

2 channels to configure.

ZT_CHANCONFIG failed on channel 1: No such device or address (6)

I attached " Eicon 4 Port Analog Card"
what is the problem
is this card support asterisk
please reply

Regards
shiv

2

hello:
you have to make sure:

  1. you comile zaptel and asterisk without any problem and in rght order.
  2. make sure the card hae been detected by your system. run lspci -vvvvv
    to check the hardware.
    regards!
    James.zhu
3

[quote=“james.zhu”]hello:
you have to make sure:

  1. you comile zaptel and asterisk without any problem and in rght order.
  2. make sure the card hae been detected by your system. run lspci -vvvvv
    to check the hardware.
    regards!
    James.zhu[/quote]

ok when i run lspci -vvvv
i get very big amount of data in which i have

01:02.0 Network controller: Dialogic Corporation Analog-4 (rev 01)
Subsystem: Dialogic Corporation Diva Analog-4 PCI v1
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- SERR- <PERR-
Latency: 32 (16000ns max), Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 5
Region 0: Memory at fcfff000 (32-bit, non-prefetchable) [size=512]
Region 1: I/O ports at ee00 [size=256]
Region 2: Memory at fb000000 (32-bit, non-prefetchable) [size=16M]
Region 3: Memory at fcf80000 (32-bit, non-prefetchable) [size=256K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [48] #06 [0000]
Capabilities: [4c] Vital Product Data

but
when i run command /sbin/ztcfg -vv
i face the same problem
Regards :
Shiv