TDM410 FXS no dialtone

Hi,

We’ve purchased a TDM410 card for our Asterisk PBX with four FXS modules. The module is installed, recognised by the system, and seems to be configured OK. The power cable has been connected to the card. I’ve edited dahdi_chan.conf and set up extensions for the ports, but when I connect an analog phone, I just don’t get a dial tone. I believe I got something on a FAX the first time I connected anything, but that was it.

I’m pulling my hairs out, and I’m sure I missed something obvious. Any clues would be highly appreciated!

Thanks,
Steven


dahdi_hardware

pci:0000:11:00.0 wcte12xp+ d161:8001 Wildcard TE122
pci:0000:11:01.0 wctdm24xxp+ d161:8005 Wildcard TDM410P


cat /etc/dahdi/system.conf

Global data

loadzone = nl
defaultzone = nl

Span 1: WCT1/0 “Wildcard TE122 Card 0” (MASTER) HDB3/CCS/CRC4 ClockSource

span=1,1,0,ccs,hdb3
bchan=1-15
dchan=16

Span 2: WCTDM/0 “Wildcard TDM410P Board 1”

fxoks=32-35
echocanceller=mg2,32-35

Howdy,

Please contact Digium support directly for assistance with Digium hardware:

digium.com/support

Thank you :smile:

What is the configuation of the card
please post more detail info to here, such as chan_dahdi.conf,dahdi-channels.conf,your dialplan etc.