Moving x100P card from one PCI slot to another PCI slot

Asterisk Asterisk Support
1

I moved my working x100P card from one PCI slot to another PCI slot.

But now “ztcfg -vvv” returns:

[quote]Zaptel Configuration

Channel map:

0 channels configured.[/quote]

To confirm this “0 channels configured”,
now “asterisk1*CLI> zap show status” returns:

[quote]Description Alarms IRQ bpviol CRC4
ZTDUMMY/1 1 UNCONFIGUR 0 0 0[/quote]

How do I make the system re-identify the x100p card and get “ztcfg -vvv” to show this again:
Channel 01: FXS Kewlstart (Default) (Slaves: 01)
1 channels configured.

2

And according to “lspci -vvv” the x100p has IRQ 5.

But “cat /proc/interrupts” shows no IRQ 5

3

FWIW I had a very similar problem with a TDM11 on an IBM 300PL, solution was to completely dismantle the computer into separate components including separating the daughter (riser) board from the motherboard (which I suspect was the problem), check and clean all contacts, carefully reassemble ensuring all connections properly in place and reboot. Since then there have been no problems.

4

Irq 5 is for lpt port

be sure to disable the lpt port…best to disable everything you do not need onboard audio…do not disable the onboard USB…

5

Ok, why keep the onboard USB enabled?