Hi All,
I have some question on configure SIP Provider Inbound Call route to SIP trunk (Cisco CUCM).
I haven’t configure the extension on Asterisk, the Asterisk is the SIP Proxy for Cisco CUCM only.
May I have more information to complete this configuration.
Asterisk 2.11.0.3
CUCM 9.1
Many Thanks!
hang
For more information, see asteriskdocs.org/
Cisco CUCM is generally well behaved as the peer of a SIP trunk, so doesn’t need any special considerations on the Asterisk side.
Thanks for your information.
May I know how can I configure the below condition on Asterisk
SIP Provider DID (Inbound) -> Asterisk -> SIP Trunk -> CUCM
When I dial the DID no., I got the below error messages
pbx_config.c: Context ‘from-nwt_bad-number’ already included in ‘from-nwt’ context on include at line 1502 of /etc/asterisk/extensions_additional.conf
[2014-05-11 18:21:51] WARNING[2313] pbx_config.c: Context ‘bad-number’ already included in ‘from-nwt’ context on include at line 1503 of /etc/asterisk/extensions_additional.conf
[2014-05-11 18:21:51] WARNING[2313] pbx_config.c: Context ‘from-nwt_bad-number’ already included in ‘from-nwt_rulematch’ context on include at line 1573 of /etc/asterisk/extensions_additional.conf
[2014-05-11 18:21:51] WARNING[2313] pbx_config.c: Context ‘bad-number’ already included in ‘from-nwt-21357201_rulematch’ context on include at line 1574 of /etc/asterisk/extensions_additional.conf
The problems seems to be Asterisk can’t forward the DID call to CUCM SIP Trunk?
Many Thanks!
The error messages are because you have a context included more than once within another context. They have nothing to do with the peers.
Thanks for your information!
May I know how can I fix this issue?
I checked with extension.conf, extension_additional.conf and extension_custom.conf, I can’t find the mentioned context on there.
** I created this context from Asterisk GUI, custom contexts and custom context admin.
Many Thanks!
hang
Asterisk GUI hasn’t been supported for some time. If you need a GUI, use FreePBX.
I’m using Asterisk and FreePBX 2.11.0.7 for configuration, which seems missed something for configuration.
Thanks!
FreePBX is supported at freepbx.org/forums/