I have an E1 Link coming into an Avaya Box. It has a DS1 Card. Along with an analog card. My objective is to replace thsi entire Avaya box with an asterisk setup. I am trying to set up CAS signalling on my single E1/T1 digium card. I installed things in the following order
- libpri-1.4.11
- dahdi-linux-complete-2.4.0+2.4
- openr2-1.3.0.tar
- asterisk-1.6.2
My system.com is as follows
/etc/dahdi/system.conf
loadzone = in
defaultzone = in
span = 1,0,0,cas,hdb3
bchan = 1-15,17-31
dchan = 16
when i do a service dahdi restart i get the following error
Unloading DAHDI hardware modules: done
Loading DAHDI hardware modules:
wct4xxp: OK
wcte12xp: OK
wct1xxp: OK
wcte11xp: OK
wctdm24xxp: OK
wcfxo: OK
wctdm: OK
wcb4xxp: OK
wctc4xxp: OK
xpp_usb: OK
Running dahdi_cfg: DAHDI_CHANCONFIG failed on channel 16: Invalid argument (22)
Selected signaling not supported
Possible causes:
dchan is being used on a BRI span (use hardhdlc)
Signaling is being assigned to channel 16 of an E1 CAS span
FAILED
My configuration of the DS1 card in Avaya is as follows
DS1 CIRCUIT PACK
Location: 01A12 Name: New Link
Bit Rate: 2.048 Line Coding: hdb3
Signaling Mode: CAS
Interconnect: CO Country Protocol: 1
Interface Companding: alaw CRC? n
Idle Code: 00001111
Slip Detection? n Near-end CSU Type: other
Echo Cancellation? n
===============================================================================================
Can someone help me with my chand_dahdi.conf and system.conf.
Regards