Caller ID not displaying properly when using Digium Gateway

Hi everyone,

I’ve setup a Digium G100 VoIP gateway to replace an internal PCI VoIP card in our Asterisk PBX. When using the VoIP card the callerid entries listed in sip.conf were displayed when calling someone over the PSTN. Also the asterisk logs displayed the callerid as well, which would allow us to filter and/or drop calls depending on the phone number.

Now, though the gateway, it just displays the default number assigned to our PRI when calling out. Incoming calls also just display entries like the following - “Executing [#######@default:1] Dial(“SIP/voip-gw-00006713”, “SIP/178,20,tT”) in new stack”.

I’m wondering if anyone can point me in the right direction as far as properly configuring the gateway. We are using an older Asterisk 1.6 build.

Thanks in advanced for the help!!

Ferdinand

Depending on the third component of the version number, that version hasn’t been supported, even for security fixes, for between over 6 and just under 8 years!