No such command 'dahdi restart'

Asterisk Asterisk Support
1

I have Centos 5.5 and Asterisk 1.6.2.20 with dahdi: Version: 2.5.0 when I enter Asterisk CLI I receive the following error message when I try to restart "No such command ‘dahdi restart’ ", I know dahdi is supposedly not loaded, but when I run dmesg | less it says it has loaded the file

[quote]dahdi: Telephony Interface Registered on major 196
dahdi: Version: 2.5.0
ACPI: PCI Interrupt 0000:00:08.0[A] -> GSI 18 (level, low) -> IRQ 233
Freshmaker version: 73
Freshmaker passed register test
Module 0: Installed – AUTO FXS/DPO
Module 1: Installed – AUTO FXS/DPO
Module 2: Not installed
Module 3: Not installed
Found a Wildcard TDM: Wildcard TDM400P REV I (2 modules)
dahdi_transcode: Loaded.
INFO-xpp: revision Unknown MAX_XPDS=64 (8*8)
INFO-xpp: FEATURE: without BRISTUFF support
INFO-xpp: FEATURE: with PROTOCOL_DEBUG
INFO-xpp: FEATURE: with sync_tick() from DAHDI
INFO-xpp_usb: revision Unknown
usbcore: registered new driver xpp_usb
dahdi_echocan_mg2: Registered echo canceler 'MG2’
eth0: no IPv6 routers present
hcfpciengine: module license ‘see LICENSE file distributed with driver’ taints kernel.
Bluetooth: HIDP (Human Interface Emulation) ver 1.1
~
[/quote]

2

Hi,

Before do the asterisk installation have you installed the Dahdi driver ? If no then you need to install first then try.

Regards,

Ketan

3

He clearly has the dahdi driver loaded. The question would be whether had chan_dahdi loaded. Does help dahdi return anything. If not, run module load chan_dahdi and see if and why it isn’t loading.