Hi,
I have configured asterisk with sangoma A101 T1/E1 card. I am using wanroute for the H/W, after is et up the wan route status showing down. please help. Logs are mention below.
/var/log/mesages
29 16:31:49 KGHAPTIVR kernel:
Apr 29 16:31:49 KGHAPTIVR kernel: wanpipe1: Wanpipe device is registered to Zaptel span # 1!
Apr 29 16:31:49 KGHAPTIVR kernel: wanpipe1: TDM Free Run Timing Enabled 1 ms
Apr 29 16:31:49 KGHAPTIVR kernel: ADDRCONF(NETDEV_UP): w1g1: link is not ready
Apr 29 16:31:51 KGHAPTIVR kernel: wanpipe1: Open Circuit is detected!
Apr 29 16:31:51 KGHAPTIVR kernel: wanpipe1: Lost of Signal is detected!
Apr 29 16:31:51 KGHAPTIVR kernel: wanpipe1: E1 disconnected!
Apr 29 16:31:51 KGHAPTIVR kernel: wanpipe1: Enable transmit YEL alarm
Apr 29 16:31:55 KGHAPTIVR kernel: wanpipe1: LOS : ON
ifconfig
w1g1 Link encap:Point-to-Point Protocol
UP POINTOPOINT NOARP MTU:8 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:18 Memory:fd5b0000-fd5b1fff
Aterisk : 1.6
Dahdi : DAHDI Version: 2.6.0
Echo Canceller(s): HWEC
Configuration
SPAN 1: CCS/HDB3 Build-out: 0 db (CSU)/0-133 feet (DSX-1)
31 channels to configure.
Setting echocan for channel 1 to mg2
Setting echocan for channel 2 to mg2
Setting echocan for channel 3 to mg2
Setting echocan for channel
Wan-route status
Devices currently active:
wanpipe1
Wanpipe Config:
Device name | Protocol Map | Adapter | IRQ | Slot/IO | If’s | CLK | Baud rate |
wanpipe1 | N/A | A101/1D/A102/2D/4/4D/8| 18 | 4 | 1 | N/A | 0 |
Wanrouter Status:
Device name | Protocol | Station | Status |
wanpipe1 | AFT TE1 | N/A | Disconnected |
var/log/asterisk/messages
Ignoring any changes to ‘hasmanager’ (on reload) at line 47.
[Apr 24 15:46:14] WARNING[1687] pbx_dundi.c: Unable to look up host ‘KGHAPTIVR’
[Apr 24 15:46:14] NOTICE[1687] config.c: Registered Config Engine curl
[Apr 24 15:46:14] NOTICE[1687] pbx_ael.c: Starting AEL load process.
[Apr 24 15:46:14] NOTICE[1687] pbx_ael.c: AEL load process: parsed config file name ‘/etc/asterisk/extensions.ael’.
[Apr 24 15:46:14] NOTICE[1687] pbx_ael.c: AEL load process: checked config file name ‘/etc/asterisk/extensions.ael’.
[Apr 24 15:46:14] NOTICE[1687] pbx_ael.c: AEL load process: compiled config file name ‘/etc/asterisk/extensions.ael’.
[Apr 24 15:46:14] NOTICE[1687] pbx_ael.c: AEL load process: merged config file name ‘/etc/asterisk/extensions.ael’.
[Apr 24 15:46:14] NOTICE[1687] pbx_ael.c: AEL load process: verified config file name ‘/etc/asterisk/extensions.ael’.
[Apr 24 15:46:14] WARNING[1687] translate.c: plc_samples 160 format f
[Apr 24 15:46:14] NOTICE[1687] chan_skinny.c: Configuring skinny from skinny.conf
[Apr 24 15:46:14] WARNING[1687] chan_skinny.c: Unable to get our IP address, Skinny disabled
Please help to resolve, Thanks in advance . If any one need more information please tellme.
Email:unni.kpr@gmail.com