The both us the same driver and the configuration for 210p should work for 410p.
This is my zaptel.conf
span=1,0,0,ccs,hdb3
span=2,1,0,ccs,hdb3
bchan=1-15
dchan=16
bchan=17-31
bchan=32-46
dchan=47
bchan=48-62
loadzone=us
defaultzone=us
This is zaptel.conf
[code][channels]
context=from-pstn
switchtype=euroisdn
usecallerid=yes
hidecallerid=no
callwaiting=yes
threewaycalling=yes
busydetect=no
busycount=7
transfer=yes
echocancel=yes
echocancelwhenbridged=yes
echotraining=yes
signalling=pri_cpe ; pri_cpe = PRI slave ; pri_net = PRI master
language=ru
resetinterval=36000
relaxdtmf=yes
faxdetect=both
;overlapdial=yes
group=1
channel => 1-15
channel => 17-31
context=from-internal
group=2
switchtype=euroisdn
usecallerid=yes
hidecallerid=no
callwaiting=yes
threewaycalling=yes
;busydetect=yes
;busycount=5
transfer=yes
echocancel=yes
echocancelwhenbridged=yes
echotraining=no
language=ru
callerid=asreceived
;immediate=yes
faxdetect=no
answer=immediate
;overlapdial=no
signalling=pri_net
channel => 32-46
channel => 48-62[/code]
This configuration perfectly works for my te210p. Recently I decided to upgrade and instead of te210p plugged in the te410p. Card has been detected. ztcfg shows that everything is ok. Zttool shows that there are no alarms.
When I start asterisk D-channel on span 2 is up and I can use but D-channel for span 1 (this is incoming line from my telco) is down.
So what can I do here? Please, give some advice.
I repeat that te210p works fine with this config.
Thank you.