Hello:
After configuring FXS and FXO channels of a TDM11B card, I can make calls from the telephone attached to the TDM11B card to the outsite (the PSTN, analog line), The problem is when I try to dial from the PSTN to my asterisk box (it has to make ring the handset on the TDM card), but I got infinite:
“Poopy (00) on card 4!”
What is the problem?. I’m running latest Asterisk and Zaptel software on a lineox 4 linux.
This is the output of the wctdm module loaded with debug=1
ACPI: PCI interrupt 0000:00:08.0[A] -> GSI 19 (level, low) -> IRQ 169
Freshmaker version: 73
Freshmaker passed register test
ProSLIC on module 0, product 0, version 2
ProSLIC on module 0 seems sane.
ProSLIC on module 0 powered up to -75 volts (c9) in 8 ms
Loop current set to 20mA!
Post-leakage voltage: 33 volts
ProSLIC on module 0 powered up to -72 volts (c2) in 5 ms
Loop current set to 20mA!
Calibration Vector Regs 98 - 107:
98: 11
99: 10
100: 0e
101: 0e
102: 00
103: 54
104: 05
105: 2a
106: 20
107: 08
Init Indirect Registers completed successfully.
Proslic module 0 loop current is 20mA
Module 0: Installed – AUTO FXS/DPO
ProSLIC on module 1, product 0, version 0
Module 1: Not installed
ProSLIC on module 2, product 0, version 0
Module 2: Not installed
ProSLIC on module 3, product 0, version 0
VoiceDAA System: 04
ISO-Cap is now up, line side: 03 rev 03
Module 3: Installed – AUTO FXO (FCC mode)
Found a Wildcard TDM: Wildcard TDM400P REV I (2 modules)
10299583 Polarity reversed (0 -> -1)
wctdm: Card 0 Going off hook
wctdm: Card 0 Going on hook
and when receiving a call from the PSTN I see this on /var/log/messages
Mar 27 22:32:25 lineox kernel: Registered tone zone 2 (France)
Mar 27 22:32:36 lineox kernel: RING on 1/4!
Mar 27 22:32:36 lineox kernel: Poopy (ffffffff) on card 4!
Mar 27 22:32:36 lineox kernel: Poopy (00) on card 4!
Mar 27 22:32:44 lineox last message repeated 527 times
What should be the problem?. What am I doing wrong?.
my ztcfg -vvv says
Zaptel Configuration
Channel map:
Channel 01: FXO Kewlstart (Default) (Slaves: 01)
Channel 04: FXS Kewlstart (Default) (Slaves: 04)
2 channels configured.
Thanks a lot in advance for the help.