dahdi_genconf not working

Asterisk Asterisk Support
1

I am using CentOS release 5.4 kernel 2.6.18-164.el5
I compiled and installed dahdilinux and dahditools without any error . But I cant get any channels in dahdi-channels.conf .
File has only DAHDI_DUMMY .

I tried several times compiling installing but no luck yet . Please help me

dahdi_hardware pci:0000:03:00.0 wctdm- e159:0001 Wildcard TDM400P REV I

[code]
[root@localhost ~]# cat /etc/asterisk/dahdi-channels.conf
; Autogenerated by /usr/sbin/dahdi_genconf on Tue Jan 19 22:26:31 2010
; If you edit this file and execute /usr/sbin/dahdi_genconf again,
; your manual changes will be LOST.
; Dahdi Channels Configurations (chan_dahdi.conf)
;
; This is not intended to be a complete chan_dahdi.conf. Rather, it is intended
; to be #include-d by /etc/chan_dahdi.conf that will include the global settings
;

; Span 1: DAHDI_DUMMY/1 “DAHDI_DUMMY/1 (source: Linux26) 1” (MASTER) [/code]

2

Sorry about the question but is necessary. The board has FXO or FXS modules?

If yes try configure the modules manually, then run lsdahdi to view your channels

3

hi:
are you sure the PCIID is detected by the driver? run: lspci -vvvvvv

4

when type lspci -v it shows below messages,

03:00.0 Communication controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface
Subsystem: Unknown device b700:0003
Flags: bus master, medium devsel, latency 64, IRQ 129
I/O ports at e800 [size=256]
Memory at 7ebff000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2

Bst Rgds;
Dewinda