Hi reader,
I have installed on Asterisk 1.5beta the mISDN driver. It is recognised.
But the 4 LEDS on the card keep flashing whether there is a remote connection cable attached to it or not.
I need help to get it working!
Below the relevant part of dmesg.
ISDN L1 driver version 1.20
ISDN L2 driver version 1.32
mISDN: DSS1 Rev. 1.47
mISDN: HFC-multi driver Rev. 1.68
HFC-multi: card manufacturer: ‘Cologne Chip AG’ card name: ‘HFC-4S Digium Card’ clock: normal
ACPI: PCI Interrupt 0000:02:01.0[A] -> GSI 17 (level, low) -> IRQ 217
HFC-4S#1: defined at IOBASE 0xcc00 IRQ 217 HZ 1000 leds-type 2
HFC_multi: resetting HFC with chip ID=0xc revision=1
Setting GPIOs
calling vpm_init
VPM: Chip 0: ver 33
VPM: A-law mode
VPM reg 0x20 is 11
NLP Thresh is set to 2 (0x2)
VPM: A-law mode
VPM reg 0x20 is 11
NLP Thresh is set to 2 (0x2)
hfcpci_probe: DIPs(0x80) jumpers(0x9)
1 devices registered
mISDN_dsp: Audio DSP Rev. 1.29 (debug=0x0) EchoCancellor MG2 dtmfthreshold(100)
mISDN_dsp: DSP clocks every 128 samples. This equals 16 jiffies.