I have been unsuccessful at configuring my cards using the new Dahdi_cfg -vsfd 5 command (using pbx in a flash 1.3). I have two TDM 400P and a TDM140P. They show up unconfigured when I run Dahdi_tool. Any suggestions?
Don’t know if it helps or not but I had a similar issue. I had some custom parameters in /etc/modules that apparently dahdi didn’t like. So I removed those and reloaded the modules and then was able to configure. I also rebooted to make sure that the card was seen and modules were loaded at boot and to see the output of dmesg, but that’s just what I did.