Show Actual AMI in CLI

I have googled and searched, and find it odd that this hasn’t been asked. I apologize if this question is a dup.

When I run an AMI command, all I see in the CLI with verbose and debug at 30 is:

Is there anyway to see the actual command and result?
Thanks!

I think the full debug may possibly be written to the log files, but I’m not 100% sure on this one and you would get other debug output scattered in with it.
Try doing a TCP dump on Linux for the AMI port:
http://stackoverflow.com/questions/16253420/how-to-capture-asterisks-ami-and-agi-traffic-using-wireshark-in-a-textual-forma

[quote]You can use tcpdump on asterisk server(linux side) to see AMI messages:
tcpdump -i eth0 -nqtttt -s 0 -A ‘((src port 5038) or (dst port 5038))’[/quote]