Asterisk & Cisco c3660

Asterisk Asterisk Support
1

Hi All,

I have installed Asterisk 1.4.0 and the asterisk-gui on a Redhat EL 4 server. The installation went fine and all sip softphones can communicate with each other. The bit I don’t know how to configure is make Asterisk receive incoming calls from the E1 line connected to Cisco 3660 router.

I have configured the router with the following entries but still Asterisk is not receiving any calls.

dial-peer voice 2252 voip
destination-pattern 2252
session protocol sipv2
session target ipv4:192.168.1.75
codec g711ulaw

I appreciate any help in how to do such configuration

Regards,

Ramzi

2

Have you made an entry in your sip.conf file for the 3660?

3

Thank you for the reply. What sort if entry should I have in the sip.conf? I used the GUI to configure Asterisk and did not come accross anything related to Cisco.

Thank you

Ramzi

4

Here’s what I use for my 3662. Just replace the x.x.x.x with the IP address of your 3660.

[x.x.x.x]
context=default
type=friend
host=x.x.x.x
dtmfmode=rfc2833
disallow=all
allow=g729
allow=ulaw