USB Troubles


#1

If I try to load ztdummy, if freaks (see errors below). It is complaining about usb_uhci. I have usb support enabled, but when I do a lsmod (see below) it is not called usb_uhci. How do I sort this out?

My LSMOD gives me this:

uhci 24284 0 (unused)
ehci-hcd 17516 0 (unused)
usbcore 59148 1 [uhci ehci-hcd]

dmesg | grep -i usb yeilds:
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
ehci_hcd 00:10.3: VIA Technologies, Inc. USB 2.0
usb.c: new USB bus registered, assigned bus number 1
ehci_hcd 00:10.3: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4
hub.c: USB hub found
uhci.c: USB Universal Host Controller Interface driver v1.1
uhci.c: USB UHCI at I/O 0xdc00, IRQ 10
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
uhci.c: USB UHCI at I/O 0xe000, IRQ 5
usb.c: new USB bus registered, assigned bus number 3
hub.c: USB hub found
uhci.c: USB UHCI at I/O 0xe400, IRQ 11
usb.c: new USB bus registered, assigned bus number 4
hub.c: USB hub found
usb-uhci.c: $Revision: 1.275 $ time 18:53:41 Jun 5 2005
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: v1.275:USB Universal Host Controller Interface drive

Errors with modprobe ztdummy:

/lib/modules/2.4.31/kernel/drivers/usb/host/usb-uhci.o.gz: init_module: No such device
/lib/modules/2.4.31/kernel/drivers/usb/host/usb-uhci.o.gz: Hint: insmod errors can be caused by incorrect module parameters, including invalid IO or IRQ parameters.
You may find more information in syslog or the output from dmesg
/lib/modules/2.4.31/kernel/drivers/usb/host/usb-uhci.o.gz: insmod /lib/modules/2.4.31/kernel/drivers/usb/host/usb-uhci.o.gz failed
/lib/modules/2.4.31/kernel/drivers/usb/host/usb-uhci.o.gz: insmod ztdummy failed