Hi guys,
Currently I just purchased the TE205P for the installation of my ISDN30 setup. I compiled, setup the card correctly I think. When I do the ztcfg -vvv it shows all 31 channels clear, with 30 bchannels using for voice ranging from 1-15, 17-31, and 16 is the dchannel. However, when I do a cat /proc/zaptel/1 I see only 24 channels configured, and then, when I do a cat /proc/zaptel/2 I see the rest 7 channels. I setup the jumper correctly all closed to use the card in E1 mode… I’m not sure what I did wrong here but the card should just display all 31 channels on span 1 (/proc/zaptel/1) instead of spreading it accross to the second span?
Here is my zaptel.conf
bchan=1-15
bchan=17-31
dchan=16
span=1,1,0,ccs,hdb3,crc4
loadzone=sg
defaultzone=sg
Help is appreciated. Thank you.