I have a strange problem with a Linksys 2100 that I’m using for years in combination with Asterisk. I can’t get to the webinterface whatever I tried. i found this instructions:
1 Take your Phone of the hook (pick up the handset)
2 Press **** (* key 4 times) to access the Phone adaptor
3 Enter 877778 # to go to the reset menu
4 Enter 1 to confirm or Enter * (start) to cancel
The SPA-2100 will prompt for confirm, you will hear “Option Successful,â€
what you have done is DEFAULTED the system so now it will use dhcp to find an IP address. You will have to use the code to find the ip address,
Dial Prompt Description
**** “Active IVR Menu”
You will hear “Sipura configuration menu”. Enter option followed by the pound key.
110 “Check WAN IP Address”
It will announce the IP address of the WAN port.
120 “Check WAN Network Mask”
It will announce the Network mask of the WAN port.
130 “Check WAN Gateway”
It will announce the gateway of the WAN port.
140 “Check MAC Address”
It will announce the MAC address of the Sipura SPA-2100.
150 “Check Firmware Version”
It will announce the firmware version running on Sipura SPA-2100.
160 “Check Primary DNS Server IP Address”
It will announce the Primary DNS Server IP address
170 “Check WAN Port Web Server Port”
It will announce the WAN port web server port.
210 “Check LAN IP Address”
It will announce the IP address of the LAN port.
100 “Check WAN internet Connection Type”
It will announce the WAN Internet Connection Type.
101 “Set WAN Internet Connection Type”
Enter “0” to use DHCP, “1” to use Static IP, or “3” to use PPPoE.
111 “Set WAN Network Mask”
Enter IP address using numbers on the telephone keypad. Use the * (asterisk) key when entering a decimal point. Note that the WAN Internet Connection Type must be set to “Static IP”, otherwise you will hear “Invalid option”.
121 “Set WAN Gateway”
Enter network mask using numbers on the telephone keypad. Use the * (asterisk) key when entering a decimal point. Note that the WAN Internet Connection Type must be set to “Static IP”, otherwise you will hear “Invalid option”.
131 “Set WAN Gateway”
Enter IP address using numbers on the telephone keypad. Use the * (asterisk) key when entering a decimal point. Note that the WAN Internet Connection Type must be set to “Static IP”, otherwise you will hear “Invalid option”.
161 “Set Primary DNS Server IP Address”
Enter IP address using numbers on the telephone keypad. Use the * (asterisk) key when entering a decimal point.
7932 “Enable/Disable Wan Port Web Server”
Enter “1” to enable, or “0” to disable
732668 “Reboot the Sipura SPA-2100”
The Sipura SPA-2100 will reboot after you hang-up the phone.
73738 “Factory Reset”
Enter “1” to confirm, or “* (asterisk)” to cancel. Sipura SPA-2100 will inform you that the “Option Successful”
877778 “User Factory Reset”
** taken from asteriskguru.com/tutorials/s … a2100.html
For some strange reason the web interface of the ata was disabled. I found the proper code for enabling the webinterface and the probem was fixed. Still have no clue about why the webinterface was tured off