Greetings:
I am running Asterisk version 1.4.21.2
I purchased a g729a/b codec lic.
The transmit and receive rates are between 20-25kbps
From the cli show translation command, produces a table with no values for g729
There is one phone attached to a linksys pap2t ATA. If I set this device to only use the preferred g729 codec, calls will not go through.
How do I specify that traffic will only be passed using the g729 codec?
Hi
Have you followed the install instructions ? and run the test tool to get the best version and also registered the codecs correctly ?
what does “core show g729” say ?
Ian
The test tool told me to use nocona, but I have an opteron processor. After I instaled the opteron codec version it works.
Now the command g729 show, returns the number of encoders/decoders currently in use.
Is there any way to see the channel bandwith usage, that the g729 codec is consuming?
Hi
Not online but something like MRTG will show you but basicly its about 20 -30 K on average.
Ian
[quote=“darootervoice”]
Is there any way to see the channel bandwith usage, that the g729 codec is consuming?[/quote]
you can use iftop - you’ll see bandwidth per ip/port you’re dealing with