I’m able to reproduce the issue with the TDM20B. The issue goes away if I leave the PC off for “a few hours” then reboot.
To reproduce, remove and replace the card in the PCI slot. ( I remove it in the first place to test a TDM22B that I am going to RMA yet again due to the problem with FXS registers described here http://forums.digium.com/viewtopic.php?t=13133&highlight= )
When the card is put in the PCI slot, the card isn’t seen at all at boot. SuSE 10.2 doesn’t load anything automatically.
fribble:~ # ztcfg -vvd 3
Notice: Configuration file is /etc/zaptel.conf
line 0: Unable to open master device ‘/dev/zap/ctl’
Line 136: fxoks=1-2
Line 182: loadzone = us
Line 196: defaultzone=us
1 error(s) detected
fribble:~ #
I load the drivers myself:
fribble:~ # modprobe wctdm
fribble:~ # ztcfg -vvd 3
Line 136: fxoks=1-2
Line 182: loadzone = us
Line 196: defaultzone=us
Zaptel Configuration
Channel map:
Channel 01: FXO Kewlstart (Default) (Slaves: 01)
Channel 02: FXO Kewlstart (Default) (Slaves: 02)
2 channels configured.
ZT_CHANCONFIG failed on channel 1: No such device or address (6)
fribble:~ # date
Sat Jan 27 11:10:36 EST 2007
Waiting a few minutes:
fribble:~ # date
Sat Jan 27 11:14:06 EST 2007
fribble:~ # ztcfg -vvd 3
Line 136: fxoks=1-2
Line 182: loadzone = us
Line 196: defaultzone=us
Zaptel Configuration
Channel map:
Channel 01: FXO Kewlstart (Default) (Slaves: 01)
Channel 02: FXO Kewlstart (Default) (Slaves: 02)
2 channels configured.
ZT_CHANCONFIG failed on channel 1: No such device or address (6)
fribble:~ #
This will stay like this all day.