Callcounter=yes

htrakotoarimanana · August 28, 2020, 8:47pm

hello,
Where should I have to put the parameter callcounter=yes, is it in users.conf ? because in the queue the call arrive to the same member even strategy of queue is rrmemory

Thank you so much

david551 · August 28, 2020, 9:35pm

sip.conf.

If you are not using chan_sip, you are probably going for the wrong solution.

htrakotoarimanana · August 29, 2020, 5:34pm

Thank you for you reply
would you mind to give me more explanation what’s you mean please

david551 · August 29, 2020, 5:52pm

github.com

asterisk/asterisk/blob/master/configs/samples/sip.conf.sample#L741


                                ; that it won't work when using subscribecontext for your sip
                                ; user or peer (if subscribecontext is different than context).
                                ; This is also limited to a single caller, meaning that if an
                                ; extension is ringing because multiple calls are incoming,
                                ; only one will be used as the source of caller ID.  Specify
                                ; 'ignore-context' to ignore the called context when looking
                                ; for the caller's channel.  The default value is 'no.' Setting
                                ; notifycid to 'ignore-context' also causes call-pickups attempted
                                ; via SNOM's NOTIFY mechanism to set the context for the call pickup
                                ; to PICKUPMARK.
;callcounter = yes              ; Enable call counters on devices. This can be set per
                                ; device too.

; ---------------------------------------- T.38 FAX SUPPORT ----------------------------------
;
; This setting is available in the [general] section as well as in device configurations.
; Setting this to yes enables T.38 FAX (UDPTL) on SIP calls; it defaults to off.
;
; t38pt_udptl = yes            ; Enables T.38 with FEC error correction.
; t38pt_udptl = yes,fec        ; Enables T.38 with FEC error correction.
; t38pt_udptl = yes,redundancy ; Enables T.38 with redundancy error correction.

system · September 28, 2020, 5:52pm

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.